How To Do European Deer Mount?

How do you boil a deer skull for European mount?

When you’ve got as much tissue out as possible, cover the skull — not the antlers — with water and a few tablespoons of Amway dishwashing powder or its equivalent. Boil or, better yet, simmer the skull for about 1-1/2 hours (less for a small deer, as too much boiling can loosen the fragile bone connections).

What to use to whiten a European mount?

You can buy powders that you mix with water and brush onto the skull. They don’t do much other than coat the skull with white powder and do a poor job of actually whitening the bone. Hydrogen peroxide is the way to go.

How do you seal a European mount?

The best for sealing is Polycrylic clear satin spray. Just use one light coat. I hold the skull by the rack and do it by hand. It helps to rotate as you spray and Continue shortly afterwards.

Can you bury a deer head for European mount?

Easiest Way to Clean a Deer Skull: Part 1. The European Mounts are gaining popularity. You can bury the skull. Or you soak the skull in warm water for about a month (Maceration).

You might be interested:  Quick Answer: Where Was The First European Town In The Americas Built?

How much does a European deer mount cost?

North American Species

Deer – Mule Add $40 if lower jaw is included $149
Deer – Whitetail Add $40 if lower jaw is included $149
Elk Add $50 if lower jaw is included $325
Pronghorn Antelope Add $40 if lower jaw is included $149
Wild Boar / Domestic Hog $199

38

How do you whiten a deer skull with baking soda?

Add a dash of dish detergent as a degreasing agent and don’t actually boil, but simmer. Add a cup of baking soda to start, but be careful it doesn’t cause the brew to boil over. Use a pot big enough to completely submerge the skull. (Don’t boil your record-book bear or lion, as boiling will shrink the skull a bit.)

How do you boil a European mount?

Start off by adding a generous amount of high-strength soap to a pot of water. I prefer soap on the first round to help pull grease out of the skull. Bring the water to a boil, then turn the dial back a small amount until the water is at a simmer. I cannot stress this enough: DO NOT BOIL THE SKULL.

What do you use to whiten a deer skull?

Once the skull is clean, place it back into a pot of clean water to keep the skull wet. Pour half the Bleach Agent (white powder) into a bowl and slowly mix in the Hydrogen Peroxide into the powder. Add only enough liquid to make a paste that has the consistency of mayonnaise. Paint this mixture onto the entire skull.

How much is a mounted deer head worth?

The long story short is you should expect to pay a minimum of $500 for a quality deer mount, and don’t be surprised if that figure pushes to $600 or more.

Leave a Comment

Your email address will not be published. Required fields are marked *